Free UK Mainland Delivery
On all orders over £165
Free Samples
Available on all our ranges
5 Year Guarantee
On all made to measure blinds
5 Stars on Trustpilot

Fitting Neat Fit Blinds

Installation Is Quick And Easy

The end caps on the head and bottom rails simply slide between the glass and rubber gasket. This unique pressure fit design ensures simple installation with no lasting damage to your window frames. Blinds are operated using the bottom rail handle. The handle can be folded to reduce the projection of the blind to only 30mm from the glass
 

Slot

In the top left window corner, gently but firmly slot the left hand top rail tab in between the left-hand rubber gasket and the glass.
 

Slide

Gently slide the top rail up the window and ease the right hand top rail tab between the rubber gasket and glass on the right-hand side of the window. Do the same for the bottom rail.

   


Push

Push the top rail firmly towards the top of the window and bottom rails firmly towards the bottom of the window.

 

End Caps

Unique end cap design and shim system to allow for fine adjustment at point of installation
 


 

Adjusting the tension

Our neat fit blinds come on a pre-tensioned system which features a helpful adjustment metal connector under the bottom rail.
 
The tension on your blind needs to be sufficient to ensure that the blind doesn’t slide down when raised and not over-tensioned, which would result in the blind headrail itself sliding down the window.
 
A small flat-bladed screw driver is required to adjust.  You can increase /decrease tension by using the screw driver to release the cords on the connector and by adjusting the length of the loose end cord prior to re-tightening.
 
You can cut off any excessive cord but please make sure to keep enough to fine adjust later.

 

Need Help?

If you would like any further assistance, please call us on 0370 218 7042 Or email [email protected]